Oct 12, 2024 Leave a message

What is the process of spring stability testing in the spring factory

The most critical thing for the spring factory is whether the working pressure of the spring is excellent, the use of the spring is to take into account the characteristics of the spring working pressure, the spring factory for the stability test of the spring generally uses the electronic device digital display spring pressure testing machine, which is the detection of spring tension, shrinking deformation and related characteristics of the special instrument and equipment, suitable for the detection of the load in the work of the tension and compression spring in a certain working length, and can be used in the elastic load detection during the ductility period of vulcanized rubber and reeds. Then, next, the professional manufacturer of spring factory will describe the process of spring stability testing for everyone:

621f22efa6441cd69412231e02ad8b8

1. Before carrying out a formal test of the spring, the spring is reduced to the load of the test once, when the experimental load is very large than the compression and load, the compression load can be carried out as the experimental load, but the compression force is larger and can not exceed 1.5 times of the fixed compression load.

2. Advance preparation before load inspection: use a third-class standard dynamometer that matches the measurement range or a standard weight with a uniform precision to carry out the load tester to ensure that the high precision of the tester is not less than 1%; In addition, the length of the load tester is corrected by using a measuring block.

3. The inspection of the spring pressing through the load of a specific aspect ratio: the central government that places the same gauge block with the specific aspect ratio on the clutch pressure plate of the load tester, loads the load similar to the value of the client of the sample drawing on the gauge block, and then clamps the precise positioning screw or precise positioning, puts the measuring block into the measured spring, adjusts the zero position, removes the weight of the spring, presses the spring to a specific aspect ratio, and reads the relative load, and finally carries out relative changes to the myopia degree according to the deviation of the calibrated load tester.

4. The upper clutch pressure plate suppression bullet yellow just eliminated to the part, load tester omen value F0≈0.05F; The initial reading of the load test is described as F0 and its length and short number, and then loaded again to make the reading transition value of the long and short omen achieve a defined deformation.

Send Inquiry

whatsapp

Phone

E-mail

Inquiry